Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR, Power Genius, Tuner Genius and Antenna Genius Software?
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
SmartSDR v3.7.4 and the SmartSDR v3.7.4 Release Notes | SmartSDR v2.12.1 and the SmartSDR v2.12.1 Release Notes
SmartSDR v1.12.1 and the SmartSDR v1.12.1 Release Notes
Power Genius XL Utility v3.8.8 and the Power Genius XL Release Notes v3.8.8
Tuner Genius XL Utility v1.2.11 and the Tuner Genius XL Release Notes v1.2.11
Antenna Genius Utility v4.1.8
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: Question about Maestro internal battery
Tim, I ordered my Maestro over a year ago from Flex, and NEVER received this Notice you refer to, nor was they any such warning included with the actual unit. Apparently there were a lot of us that w…1 -
Re: Maestro disconnects from my 6500 even though it is hard wired through a 5 port switch
David, I had a very similar incident with my Maestro & 6500 that began on Friday 1-5-18. My Maestro had been connected via Ethernet since I installed it and had not caused a problem until Friday …1 -
Re: V3 and the Average Ham
Bill Thank you! Burt, I don't think I disrespected Joseph's opinion, but rather offered a solution to someone who does not speak for me. When you bolster your opinion by saying "most hams" …1 -
Re: Flex 6500 transmitter now has no power out on FT8
Thanks to all that offered suggestions, I tried each suggestion, but to no avail. Here was the solution that worked: I was able to finally get FT8 working again with the help of a fellow ham who spen…1 -
Re: TX delay on 6500 ?
I was having the same problem with my 6500 Receive not recovering before the station I was working had already given my report (QSO Party)and moved on. Flex suggested I save my profiles, and then do …1